VGS2 - QUESTRONIX

The Quest AV model VGS2 Graphics Splitter is small, efficient, inexpensive, very easy to use and works very nicely with VGA, SVGA, XGA, etc. Because the VGS2 runs from a single 12Vdc supply, it can readily be used in portable applications or in remote locations.

With the optional remote switch assembly CST1 (optional - not included) you can make the extra output go completely Black while you load files or to attract your audience's attention, without affecting your monitor in

any way and without sending any unintended pictures to your audience... Very professional!

The VGS2 comes ready to use! Supplied with a high quality cable to connect to your PC or laptop and an Australian- approved 12V power supply. There are no adjustments, dummy plugs or confusing miniature switches to configure, just plug it in and use it right away.

You can't go wrong - the connectors are clearly labelled to prevent confusion.

No damage can be done to the VGS2 or your PC and monitors, projectors, LCD displays, etc. if incorrectly connected as all inputs and outputs are protected.

We have off-the-shelf HQ cables and adaptors available and we can also custom-make HQ cable assemblies to virtually any length you require or you can use standard 75 ohm BNC video cables in conjunction with our very neat little DB95 adaptor.

The VGS2 carries a full 12 month parts and labour warranty and is made by us in Australia.

SPECIFICATIONS
INPUT
Connector:	15 pin high-density female D-sub
Cable:	High Quality fully shielded 15pin high-density male to male.
RGB signals:	Analogue video, 0.7 - 1.0Vp-p nominal, 75 ohm terminated
H & V Sync:	TTL level, horizontal and vertical, 2K2 pull-up

MONITOR OUTPUT
Connector:	15 pin high-density female D-sub
RGB Gain:	Buffered, unity ą10%, fixed gain, to feed 75 ohm inputs, maximum recommended cable length 20Mtrs
H & V Sync:	Buffered, TTL compatible, polarity same as input, protected against short-circuit
RGB Bandwidth:	>240MHz

BOOSTED OUTPUT
Connector:	15 pin high-density female D-sub
RGB Gain:	Buffered, factory set to unity, up to +6dB available (Internal R,G & B adjustments), 75 ohm impedance
H & V Sync:	Buffered, TTL compatible, polarity same as input, protected against short-circuit
RGB Bandwidth:	-3dB @ >=240MHz, with standard 0.7Vp-p signals into 75 ohm loads.

GENERAL
Special features:	Extra Output RGB can be blanked, H&V sync's unaffected. 12Vdc operation, reverse polarity protected
Accessories included:	1 each: Australian approved 12Vdc 200mA power supply, 1.2Mtr male-male VGA HQ input cable
Optional Accessories:	CST1 Remote control cable for blanking Boosted Output, 6Mtrs Moulded HQ cables up to 50Mtrs long - click here Custom length HQ cables for permanent installations - click here Standard and custom wall-plates - click here DB95 adaptor for really long cabling - click here
Optional Modification:	Second boosted output instead of fixed gain monitor output. No extra charge if specified at time of ordering.
Dimensions:	WxDxH: 140 x 115(max) x 36mm, VGS2 only, no cables connected.
Weight:	Packed 980gms, VGS2 only 245gms.

	Run two screens from a single computer
	With our HQ cable assemblies the extra screen can be 65 Metres or more away!
	Impressive presentations, Effective teaching
	High resolution, Crystal clear, 240MHz BW
	I n e x p e n s i v e !